# dmesg Linux version 2.6.11.10-xen0 (root@xendemo) (gcc version 3.3.6 (Debian 1:3.3.6-5)) #2 Thu May 26 18:32:25 BST 2005 BIOS-provided physical RAM map: Xen: 0000000000000000 - 000000000fc00000 (usable) 0MB HIGHMEM available. 252MB LOWMEM available. On node 0 totalpages: 64512 DMA zone: 64512 pages, LIFO batch:15 Normal zone: 0 pages, LIFO batch:1 HighMem zone: 0 pages, LIFO batch:1 DMI 2.3 present. IRQ lockup detection disabled Allocating PCI resources starting at 0fc00000 (gap: 0fc00000:f0400000) Built 1 zonelists Kernel command line: ro root=/dev/ram0 ramdisk_size=32768 init=/sbin/cow_root.sh console=tty 3 Initializing CPU#0 PID hash table entries: 1024 (order: 10, 16384 bytes) Xen reported: 2004.572 MHz processor. Using tsc for high-res timesource Console: colour VGA+ 80x25 Dentry cache hash table entries: 32768 (order: 5, 131072 bytes) Inode-cache hash table entries: 16384 (order: 4, 65536 bytes) vmalloc area: d0800000-fb7fe000, maxmem 34000000 Memory: 234752k/258048k available (1660k kernel code, 23208k reserved, 641k data, 128k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay loop... 3997.69 BogoMIPS (lpj=19988480) Security Framework v1.0.0 initialized SELinux: Disabled at boot. Mount-cache hash table entries: 512 (order: 0, 4096 bytes) CPU: After generic identify, caps: bfebfbff 00000000 00000000 00000000 00004400 00000000 00000000 CPU: After vendor identify, caps: bfebfbff 00000000 00000000 00000000 00004400 00000000 00000000 CPU: Trace cache: 12K uops, L1 D cache: 8K CPU: L2 cache: 128K CPU: After all inits, caps: bfebd3f1 00000000 00000000 00000080 00004400 00000000 00000000 CPU: Intel(R) Celeron(R) CPU 2.00GHz stepping 07 Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Checking 'hlt' instruction... disabled checking if image is initramfs...it isn't (bad gzip magic numbers); looks like an initrd Freeing initrd memory: 17764k freed NET: Registered protocol family 16 PCI: Using configuration type Xen Linux Plug and Play Support v0.97 (c) Adam Belay xen_mem: Initialising balloon driver. usbcore: registered new driver usbfs usbcore: registered new driver hub PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) Enabling SiS 96x SMBus. PCI: Ignoring BAR0-3 of IDE controller 0000:00:02.5 PCI: Probing PCI hardware (bus 01) PCI: Probing PCI hardware VFS: Disk quotas dquot_6.5.1 Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x0 Initializing Cryptographic API isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found serio: i8042 AUX port at 0x60,0x64 irq 12 serio: i8042 KBD port at 0x60,0x64 irq 1 io scheduler noop registered io scheduler anticipatory registered io scheduler deadline registered io scheduler cfq registered RAMDISK driver initialized: 16 RAM disks of 32768K size 1024 blocksize Xen virtual console successfully installed as ttyS Event-channel device installed. Initialising Xen netif backend PCI: Obtained IRQ 9 for device 0000:00:03.3 ehci_hcd 0000:00:03.3: Silicon Integrated Systems [SiS] USB 2.0 Controller ehci_hcd 0000:00:03.3: irq 9, pci mem 0xe6000000 ehci_hcd 0000:00:03.3: new USB bus registered, assigned bus number 1 PCI: cache line size of 128 is not supported by device 0000:00:03.3 ehci_hcd 0000:00:03.3: USB 2.0 initialized, EHCI 1.00, driver 10 Dec 2004 hub 1-0:1.0: USB hub found hub 1-0:1.0: 6 ports detected usbcore: registered new driver usbkbd drivers/usb/input/usbkbd.c: :USB HID Boot Protocol keyboard driver usbcore: registered new driver usbmouse drivers/usb/input/usbmouse.c: v1.6:USB HID Boot Protocol mouse driver input: AT Translated Set 2 keyboard on isa0060/serio0 NET: Registered protocol family 2 IP: routing cache hash table of 2048 buckets, 16Kbytes TCP established hash table entries: 8192 (order: 4, 65536 bytes) TCP bind hash table entries: 8192 (order: 3, 32768 bytes) TCP: Hash tables configured (established 8192 bind 8192) NET: Registered protocol family 8 NET: Registered protocol family 20 RAMDISK: cramfs filesystem found at block 0 RAMDISK: Loading 17764KiB [1 disk] into ram disk... done. VFS: Mounted root (cramfs filesystem) readonly. Freeing unused kernel memory: 128k freed Linux agpgart interface v0.100 (c) Dave Jones agpgart: Detected SiS 655 chipset agpgart: Maximum main memory to use for agp memory: 200M agpgart: AGP aperture is 64M @ 0xe8000000 NET: Registered protocol family 1 Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx SIS5513: IDE controller at PCI slot 0000:00:02.5 PCI: Obtained IRQ 11 for device 0000:00:02.5 SIS5513: chipset revision 0 SIS5513: not 100% native mode: will probe irqs later SIS5513: SiS 962/963 MuTIOL IDE UDMA133 controller ide0: BM-DMA at 0xa400-0xa407, BIOS settings: hda:DMA, hdb:DMA ide1: BM-DMA at 0xa408-0xa40f, BIOS settings: hdc:DMA, hdd:DMA Probing IDE interface ide0... hda: Maxtor 6Y060L0, ATA DISK drive hdb: IBM-DTLA-307030, ATA DISK drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 Probing IDE interface ide1... hdc: TOSHIBA DVD-ROM SD-M1712, ATAPI CD/DVD-ROM drive hdd: AOPEN CD-RW CRW4852 1.00 20030123, ATAPI CD/DVD-ROM drive ide1 at 0x170-0x177,0x376 on irq 15 Intel 810 + AC97 Audio, version 1.01, 18:24:46 May 26 2005 PCI: Obtained IRQ 10 for device 0000:00:02.7 i810: SiS 7012 found at IO 0x9000 and 0x9400, MEM 0x0000 and 0x0000, IRQ 10 i810_audio: Audio Controller supports 6 channels. i810_audio: Defaulting to base 2 channel mode. i810_audio: Resetting connection 0 ac97_codec: AC97 Audio codec, id: ADS112 (Analog Devices AD1981) i810_audio: AC'97 codec 0 supports AMAP, total channels = 6 ohci_hcd: 2004 Nov 08 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI) PCI: Obtained IRQ 5 for device 0000:00:03.0 ohci_hcd 0000:00:03.0: Silicon Integrated Systems [SiS] USB 1.0 Controller ohci_hcd 0000:00:03.0: irq 5, pci mem 0xe7000000 ohci_hcd 0000:00:03.0: new USB bus registered, assigned bus number 2 hub 2-0:1.0: USB hub found hub 2-0:1.0: 3 ports detected PCI: Obtained IRQ 9 for device 0000:00:03.1 ohci_hcd 0000:00:03.1: Silicon Integrated Systems [SiS] USB 1.0 Controller (#2) ohci_hcd 0000:00:03.1: irq 9, pci mem 0xe6800000 ohci_hcd 0000:00:03.1: new USB bus registered, assigned bus number 3 hub 3-0:1.0: USB hub found hub 3-0:1.0: 3 ports detected sis900.c: v1.08.07 11/02/2003 PCI: Obtained IRQ 3 for device 0000:00:04.0 0000:00:04.0: Realtek RTL8201 PHY transceiver found at address 1. 0000:00:04.0: Using transceiver found at address 1 as default eth0: SiS 900 PCI Fast Ethernet at 0x8800, IRQ 3, 00:0c:6e:17:96:e2. e100: Intel(R) PRO/100 Network Driver, 3.3.6-k2-NAPI e100: Copyright(c) 1999-2004 Intel Corporation PCI: Obtained IRQ 3 for device 0000:00:0b.0 e100: eth1: e100_probe: addr 0xef000000, irq 3, MAC addr 00:A0:C9:67:C8:B5 via-rhine.c:v1.10-LK1.2.0-2.6 June-10-2004 Written by Donald Becker PCI: Obtained IRQ 11 for device 0000:00:0c.0 eth2: VIA Rhine II at 0x18000, 00:90:cc:07:f7:c2, IRQ 11. eth2: MII PHY found at address 8, status 0x782d advertising 01e1 Link 45e1. Probing IDE interface ide2... Probing IDE interface ide3... Probing IDE interface ide4... Probing IDE interface ide5... hdc: ATAPI 48X DVD-ROM drive, 128kB Cache, UDMA(33) Uniform CD-ROM driver Revision: 3.20 hdd: ATAPI 40X CD-ROM CD-R/RW drive, 2048kB Cache, UDMA(33) SCSI subsystem initialized ISO 9660 Extensions: RRIP_1991A loop: loaded (max 32 devices) device-mapper: 4.4.0-ioctl (2005-01-12) initialised: dm-devel@redhat.com Generic RTC Driver v1.07 input: PS/2 Generic Mouse on isa0060/serio1 mice: PS/2 mouse device common for all mice ts: Compaq touchscreen protocol output cdrom: open failed. hda: max request size: 128KiB hda: 120103200 sectors (61492 MB) w/2048KiB Cache, CHS=65535/16/63, UDMA(133) hda: cache flushes supported /dev/ide/host0/bus0/target0/lun0: p1 p2 p3 p4 < p5 p6 p7 p8 > p2: hdb: max request size: 128KiB hdb: 60036480 sectors (30738 MB) w/1916KiB Cache, CHS=59560/16/63, UDMA(100) hdb: cache flushes not supported /dev/ide/host0/bus0/target1/lun0: p1 p2 p3 NET: Registered protocol family 10 Disabled Privacy Extensions on device c0317d40(lo) IPv6 over IPv4 tunneling driver Bridge firewalling registered xen-br0: no IPv6 routers present mtrr: reg: 2 has count=0 mtrr: reg: 2 has count=0 mtrr: reg: 2 has count=0 mtrr: reg: 2 has count=0 mtrr: reg: 2 has count=0 mtrr: reg: 2 has count=0 device vif1.0 entered promiscuous mode xen-br0: port 1(vif1.0) entering learning state xen-br0: topology change detected, propagating xen-br0: port 1(vif1.0) entering forwarding state vif1.0: no IPv6 routers present # mount rootfs on / type ext2 (rw,noatime) proc on /proc type proc (rw) sysfs on /sys type sysfs (rw) devpts on /dev/pts type devpts (rw,gid=5,mode=620) tmpfs on /dev/shm type tmpfs (rw) usbfs on /proc/bus/usb type usbfs (rw) # df Filesystem 1K-blocks Used Available Use% Mounted on rootfs 1265732 820560 380876 69% / tmpfs 126364 0 126364 0% /dev/shm # uname -a Linux xendemo 2.6.11.10-xen0 #2 Thu May 26 18:32:25 BST 2005 i686 GNU/Linux